WANHAO DUPLICATOR I3 MINI - Surface Coating and General Maintenance; 6.1.4 Surface Coating; MAINTENANCE

30
FINISHING
6.1.4 Surface Coating
Finally,to make tour models more presentable,follow these steps;
1. Ensure that safety goggles and a mask are worn for protection
2. Ensure that your 3D object is clean and free from dust
3. Spray your model using an acrylic based primer,following the directions of your primer
4. Allow appropriate time to dry before applying additional coats
5. Spray your model using an acrylic based paint of your colour.Allow appropriate time to dry
6. Spray your model using an acrylic based varnish,following the direchtions of your varnish
Allow appropriate time to dry before applying additional coats.
NOTE:
Different paint types are also compatible with PLA.Consult your local paint supplier for
the best compatibility for your intended purpose.
Congratulations!Your 3D object now looks like a professionally nished product!
MAINTENANCE
The maintenance of Duplicator I3 Mini should be conducted by skilled person only.Always
unplug the printer before doing maintenance or modications. In order to have a smoothly
working Duplicator I3 Mini it is important to maintain it correctly.Please follow the safety/
deterioration checks during maintenance:
* Check condition of all rubber belts
* Oil the lead screens with light machine oil(sewing machine oil)
* Check the condition of the power cable.Make sure there are no cracks in the sheath
* Check the condition of the wiring on the printer to ensure nothing is pinched of damaged
* Check the fans are operational during print
* Check the chassis is secure.Tighten any screws if there is ex in the frame