Wasp WWS650 - Maxicode Set Length 2

Symbology Selection Enter/Exit Programming Mode
Product Reference Guide 191
Maxicode Set Length 2
This feature specifies one of the bar code lengths for Maxicode Length Control on page 190.
Length 2 is the maximum label length if in Variable Length Mode, or the second fixed length if
in
Fixed Length Mode. Characters can be set from 0001 to 0145 characters in increments of
0001 (pad with zeroes).
See page 245 for detailed instructions on setting this feature.
$CMXL2
Select Maxicode Length 2 Setting
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
a
t left followed by the digits from the Alphanumeric
characters in
Appendix D, Keypad representing
your desired character(s). End b
y scanning the ENTER/
EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
~
CANCEL
DEFAULT
Length 2 is 0145 Characters