Product Reference Guide
25
RS-232 INTERFACE
BAUD RATE on page 26
DATA BITS on page 27
STOP BITS on page 27
PARITY on page 28
HANDSHAKING CONTROL on page 29
Use the programming bar codes in this section if m
odifications to the standard RS-232 inter-
face settings are ne
cessary to meet your system’s requirements. Additional settings which
apply to both the RS-232 and USB interfaces are available in the next section, "RS-232/USB-
Com Interfaces" starting on
page 30.
Reference Appendix B, Standard Defaults for a listing of standard factory
settings.
To Next Page
Loading...
