ENCORE
®
700 METERING PUMP
Table 4.3 - Troubleshooting (Cont'd)
Motor is Hot, But Starts
When Cool.
Overload protector has opened.
Check supply voltage. Check
excessive pressure at point of
application. Check binding pump
Belt is Noisy.
Worn belt. Pulley misaligned.
Pulley out of round; wobbly.
Replace belt. Adjust tension by
the tensioning screw. Align pulley
per procedure found on in Section
4.4.6 (Gearbox Cover Installation
for Pulley Drive), steps q through u.
WT.440.400.001.UA.IM.1012
52
To Next Page
Loading...