EasyManua.ls Logo

Water Right Impression Plus Series - PROGRAMMING PROCEDURES; Setting Time and Day; Core Programming Settings

Water Right Impression Plus Series
36 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
8
1. Set time of day:
PROGRAMMING PROCEDURES
NOTE: The manufacturer has preset the unit so that the gallons between regenerations
will be automatically calculated after the hardness is entered. Press NEXT to cycle to the
next step or REGEN to return to the previous step.
STEP 1 – Press
NEXT and + simultaneously for 3 seconds.
STEP 2 HARDNESS: Set the amount of hardness in grains per gallon
(default 20) using the + or buttons. The allowable range
is from 1 to 150 in 1 grain increments.
NOTE: If a resin media is used in the softener, increase
the grains per gallon if soluble iron is present (1 ppm = 4 gpg).
This display will show “–nA– (not available)” if “FILTER”
is selected or if “AUTO” is not factory set.
STEP 3 DAYS BETWEEN REGENERATION (DAY OVERRIDE):
The manufacturer has factory set OFF as the default. When set to “OFF”,
regeneration initiation is based solely on gallons used. If any number is set
(allowable range from 1 to 28), a regeneration initiation will be called for
on that day even if a sufficient number of gallons were not used to call for
a regeneration. By default, this regeneration will occur at 2:00 a.m.
Set Day Override using + or buttons (6 is recommended):
• set number of days between regeneration (1 to 28); or
• set to “OFF” (default)
2. Programming:
Time of day should only need to be set after extended power outages or when daylight saving time begins or ends.
If an extended power outage occurs, the time of day will flash on and off indicating that the time should be reset.
STEP 1 – Press
SET CLOCK.
STEP 2CURRENT TIME (HOUR): Set the hour of the day using + or buttons.
AM/PM toggles after 12. Press
NEXT to go to step 3.
STEP 3CURRENT TIME (MINUTES): Set the minutes using + or buttons. If it is desired to back up
to the previous step press
REGEN button once. Press NEXT to go to step 4.
STEP 4CURRENT DAY: Set the day of the week using + or buttons. Pressing
NEXT will exit SET CLOCK and
return to the general operating display.
2
3 4
1
1
2
3
TIME HOUR
SET
2:00
AM
TIME MINUTES
SET
2:10
AM
CURRENT DAY
SET
MON
DAYS BETWEEN REGEN
SET
OFF
WATER HARDNESS
SET
20
GR

Related product manuals