D
David GreeneSep 2, 2025
What does error code E3 mean on my Water Right Impression RC?
- NnelsoncrystalSep 2, 2025
If your Water Right Water Dispenser displays error codes E3, Err – 1003, or Err – 103, it means the control valve motor ran too long and couldn't find the next cycle position. This could be because the drive bracket isn't snapped in properly, preventing the reduction gears and drive gear from interfacing correctly. Snap the drive bracket in properly, then press the NEXT and REGEN buttons for 3 seconds to resynchronize the software with the piston position, or disconnect the power supply from the PC board for 5 seconds and then reconnect it.






