Wayne P250 series User Manual

INSTALLATION OF BURNER
INSTALLATION OF THE BURNER MUST BE DONE BY A QUALIFIED INSTALLER IN ACCORDANCE WITH
REGULATIONS OF THE NATIONAL FUEL GAS CODE ANSI Z223.1/NFPA 54, AND IN COMPLETE ACCORDANCE WITH
ALL LOCAL CODES AND AUTHORITIES HAVING JURISDICTION.
INCORRECT INSTALLATION, ADJUSTMENT, OR MISUSE OF THIS BURNER WILL VOID THE WARRANTY
AND COULD RESULT IN DEATH, SEVERE PERSONAL INJURY, OR SUBSTANTIAL PROPERTY DAMAGE.
A QUALIFIED INSTALLER IS THE PERSON WHO IS RESPONSIBLE FOR THE INSTALLATION AND ADJUSTMENT OF
THE EQUIPMENT AND WHO IS LICENSED TO INSTALL GAS-BURNING EQUIPMENT IN ACCORDANCE WITH ALL
CODES AND ORDINANCES.
BURNER IS SHIPPED AT MINIMUM RATE AND MAX AIR BURNER MAY NOT
LIGHT IN THIS CONFIGURATION AND WILL NEED AIR ADJUSTMENT
CSA CERTIFICATE NUMBER: 1156769
MODELS
WAYNE COMBUSTION SYSTEMS
801 GLASGOW AVE.
FORT WAYNE, IN 46803
PHONE: (260) 425-9200
(855) WAYNECS
(800) 443-4625
FAX: (260) 424-0904
www.waynecombustion.com
ALL P250 AND P265 SERIES
GAS BURNERS
SPECIFICATIONS
BURNER MODELS
P250AF & P250AF-EP & P250AFDI
P265 & P265EP & P265DI
P265F & P265FEP &P265FDI
MINIMUM INPUT
50,000 Btu/hr (15 kW)
65,000 Btu/hr (19 kW)
65,000 Btu/hr (19 kW)
MAXIMUM INPUT
250,000 Btu/hr (73 kW)
200,000 Btu/hr (59 kW)
200,000 Btu/hr (59 kW)
ELECTRICAL Power Supply – 115V/60HZ 1 Ph.
MOUNTING: Adjustable Flange is Standard; Pedestal Mount is Optional
FUELS
Natural & L.P. Gas
Natural & L.P. Gas
Natural & L.P. Gas
If the information in these instructions is not followed exactly, a fire or
explosion may result causing property damage, personal injury or death.
P265F Gas Burner
P250AF Gas Burner
Manual 101220 | Revision C | Publication Date: 7/11/14
NOTE: Dimensions in () are informational only. English values take priority.

Wayne P250 series Specifications

General

Brand	Wayne
Model	P250 series
Category	Indoor Fireplace
Language	English

Summary

Wayne Gas Burner Models and Specifications

P250 and P265 Series Gas Burners

Overview of available gas burner models and their series.

Burner Performance Specifications

Details on input ratings, fuels, and electrical requirements for burner models.

Installation and Setup Procedures

Flue Pipe, Chimney, and Draft Hood Inspection

Ensures proper venting of combustion gases and chimney integrity.

Orifice Size and Gas Rate Determination

Chart to select the proper orifice size for natural gas and propane.

Gas Piping Inspection and Sizing

Guidelines for inspecting, sizing, and installing gas supply piping.

Limit Control and Thermostat Installation

Proper installation and inspection of safety limit controls and room thermostats.

Burner Initial Start Up

Direct Ignition Burner Start Up

Electronic Pilot Burner Start Up

Standing Pilot Burner Start Up

Gas Conversion Instructions

Service and Troubleshooting

Direct Ignition Normal Operation Check

Electronic Pilot Normal Operation Check

Troubleshooting Direct Ignition Systems

Guides for diagnosing and resolving issues with direct ignition.

Troubleshooting Electronic Pilot Systems

Guides for diagnosing and resolving issues with electronic pilot controls.

Component Troubleshooting and Diagnosis

Service Hints for Common Issues

Wiring Diagrams

Direct Ignition System Wiring Diagrams

Electronic Pilot System Wiring Diagrams