APPLICATIONS | 37
Always cut at a right angle to the cung material, in order to prevent damage to the blades.
Also, the ps of the shear blades must not be more than 5 mm apart during the cung process.
If this value is exceeded, the cung process must be cancelled and then started again.
CAUTION!
Do not sever any parts with loose ends, as this can result in personal injury
due to parts ying o.
ATTENTION!
When cung high-strength vehicle body parts, such as shock absorbers,
hinges or steering columns, the shear blades (arms) may cause severe
damage.
In its closed state, the rescue ram is posioned for pushing away vehicle body parts. Therefore,
make sure that the ram is placed as centrally as possible and at a right angle to the load.
The pushing head can be rotated on the piston rod to guarantee beer aachment opons.
To Next Page
Loading...
