WEBTEC HPM - Display format (DISP)

83V2.0/02.11
Connectingthesensors/displayfunctions
ENGLISH
• The following message will be displayed if no sensor is connected
to the device:
5.1 Displayformat(DISP)
Press DISP (once)
It is possible to change the display format by
pressing DISP (once only).
Available for selection:
ACT = Actual values
MIN = Minimum values
MAX = Maximum values (pressure spikes)
FS = Full scale (upper range value)
TEMP = Temperature display
The TEMPdisplay applies only to 'SCPT' type sensors.