WEBTEC HPM - Differential value alignment (IN1=IN2)

87V2.0/02.11
Connectingthesensors/displayfunctions
ENGLISH
5.6 Differentialvaluealignment(IN1=IN2)
Press and holdIN1=IN2(2 s)
Carry out differential value alignments at below operating pres-
sure. Connect two pressure sensors to the same connection
(T-adapter). ∆p-calibration sets the tolerance of the sensors in
relation to one another to zero.
This setting remains stored; it is valid only for the respective op-
erating pressure.