Getting Started
Buttons for Mode Switch
See figure below for buttons.
NK280B supports five modes: Auto, Jog, Handle, REF.Point and Stepping mode.
When you want to control the machine movement by handwheel, select Handle mode.
Default override for Handle and Stepping mode is X100.
Select XUD to custom the step length.
ESTOP Switch
When the machine is in danger, press emergency stop button to completely stop the machine.
When the danger is cleared, rotate the switch in clockwise direction to remove emergency alarm.
Buttons for Auxiliary Functions
Buttons are used for directly enabling some frequently-used operations or turning on or off
some ports.
Buttons are:
Make the program run in simulation mode.
Enable handwheel guide function.
Enable the single block function. Once the
button is pressed, one line of code block will
be executed.
Enable or disable the coolant port to turn on
or off the coolant.
Enable or disable the blowing port to start or
stop blowing.
9
To Next Page
Loading...
