Operation
• Press Handle button to activate Handwheel mode, and use handwheel to move X-axis.
• Press Jog button to activate Jog mode, and press X+ or X- button to move X-axis.
4. (Optional) If actual moving direction is opposite with setting value, change to the opposite
value.
Current setting value for parameter Axis Direction (X) is 1, manually move X-axis but X-axis
moves towards the negative direction. Change setting value to -1.
Related reference
Parameter for Axis Direction
Parameters that decide moving direction of each axis.
Operation
The Operation is designed to help users (mainly manufacturers) to understand main operations
involved during machining.
You can start machining workpiece according to the following steps:
Table 2: Overview of Workpiece Machining Process
Step Operation Reference
1 Execute warm-up and trial run. Execute Warm-up and Trial
Run
2 Manually moves each axis to check its movement. Manually Move Machine
Tool
3 In general double Z software, switch software
configuration.
Switch Software
Configuration
4 Return to machine origin. Return to Machine Origin
5 In general double Z software, select Z-axis. Select Z-axis
6 Calibrate tool. Calibrate Tool
7 Set tool No. Set Tool Number
8 Set workpiece coordinate. Set Workpiece Coordinate
9 Manage machining technics. Manage Technics
10 Connect network. Connect Network
11 Load program file. Manage Program Files
12 Set related parameters necessary for machining. Set Parameters
13 To have a general idea about the program and tool
path, execute simulation.
Simulate
14 Run program. Run Program
23
To Next Page
Loading...
