Operation
Make workpiece compensation as follows:
• Dimension(J): 120.000
• Dimension(K): 80.000
• Direction, Order, Comp Mode: custom
You can get workpiece whose dimension is 120mm*80mm.
Compensate Screw Error
It includes screw pitch error compensation and backlash compensation.
To compensate screw error:
1. Press Advanced > = > F7.
Screw Error Compensation interface shows.
2. Do one of the following:
Operation Step
Manually set
compensation
data.
1. Press shortcut key T/S/P to select an axis.
2. Do one of the following:
• Press F1 to insert number for compensation data and set related
data by direction key ↑/↓/←/→/ > Enter.
• Press F3 and press T/S/P to enter setting values.
The system automatically generates a group of compensation data
into the compensation table.
3. Press X/Y/Z to set backlash for each axis.
4. Press F6 to make setting effective.
Import
compensation
data.
1. Press F4.
2. Do one of the following:
• Press F1 to use imported compensation data directly.
• Press F2 to add the new compensation value to the old value.
3. Press F6 to make setting effective.
Export
compensation
data.
Press F5 to export current compensation data to USB flash disk.
Except no need to set backlash for bidirectional compensation, other settings for
bidirectional compensation is the same with settings for unidirectional compensation.
Manage Tool Life
Note that the interface is different in General Three-axis Software and Double Z Software.
Tool life decides how many times a tool can be used for machining task.
To set life of a tool:
1. Press Advanced > = > F3 to open Technics Management interface.
32
To Next Page
Loading...
