NK280B Parameter Reference
Table 6: Parameters Related with Encoder Function
Parameter Name Description
Encoder Feedback Whether to use the encoder feedback function
or not.
Encoder Type 0: Incremental encoder; 1: Absolute encoder.
Encoder Digit The digit number of the encoder.
Parameters for Handwheel Operation
It includes parameters that will influence the usage of handwheel.
Table 7: Parameters Related with Handwheel Operation
Parameter Name Description
Precise Pulse Counting Yes: Machine moves the exact pulses
generated by handwheel; No: Machine moves
only when the handwheel is turning.
Handwheel Direction Relations between the directions of handwheel
turning and axes motion. 1: Same direction; -1:
Opposite direction.
Handwheel Acceleration Smaller value gets smoother handwheel
movements.
Handwheel Connection 0: Connect the handwheel with Lambda
controller; 1: Connect the handwheel with
NK280B host.
Parameters for Workbench Range
Workbench Range refers to valid movement ranges or the travelling range in X, Y and Z
direction. It serves as soft limits to protect the machine.
Setting values for the upper limits and the lower limits are decided by specification of the
machine. When you set the range for the first time, please carefully observe actual moving
distance of the axes.
Table 8: Parameters Related with Worktable Stroke
Parameter Name Description
Negative Travel Limit (MCS) The positive travel limit in each axis.
Positive Travel Limit (MCS) The negative travel limit in each axis.
Enable Workbench Range Check Whether to check the workbench range.
Parameters for Prompt
Parameters that decides prompt method for certain functions or actions.
50
To Next Page
Loading...
