Operation
Step Operation Reference
15(Optional)During machining, check current program
information, adjust motion track, return to fixed
point, workpiece origin and etc.
Adjust Track View
Return to Workpiece Origin
Return to Fixed Point
Execute Warm-up and Trial Run
After power up, it is not recommended to start machining directly without knowing actual
working conditions. In this case, you can use Warm-up and Trial-run function to test the
machine, including working conditions like spindle rotation, etc.
Use Warm-up and Trial-run function in following situations:
• After restarting the software
• After restarting the machine
• After all axes have been returned to the machine origin
To start warm-up and trial-run:
1. Press corresponding buttons on operational panel to turn to Jog, Handwheel or Stepping
mode.
Note that Warm-up and Trial-run is not available in REF mode.
2. Press State > A > F5 to open Warm-up and Trial-run interface.
3. Set parameters.
4. Press F1 to start warm-up and trial-run.
Any stopping actions (including manual stop, ESTOP, stopping caused by switch limit, etc.)
will stop warm-up and trial-run process.
Manually Move Machine Tool
Through related parameter settings and axis direction keys, you can control the movement of
machine tool.
To manually move machine tool:
1. Set running speed and step length.
a) Press corresponding mode button on operational panel to turn to
Jog/Handwheel/Stepping mode.
b) Press State > A.
Coor-Manual interface shows.
c) To set parameters Manual High Speed, Manual Low Speed, Custom Step of XY and Custom
Step of Z, press direction key ↑/↓/←/→ > Enter.
You can also set parameters Manual High Speed and Manual Low Speed in the Machine
Param interface.
2. Move the machine tool:
a) Select feed mode.
24
To Next Page
Loading...
