System Maintenance
Prepare a USB flash disk with the mirror image file named “NK280B_NK_Rx.x.x.nb0”.
To update the mirror image:
1. Insert the USB flash disk with mirror image file into NK280B host.
2. Power on NK280B and simultaneously press M key several times .
It turns to an interface with several system updating options.
3. Press T key to choose “Update System” command.
The system loads the mirror image file from USB flash disk.
4. After successfully loading the mirror image, press Y key to confirm and go on.
After updating the mirror image, you need to install the CNC software, otherwise, it is only an
empty system.
Install Software
It helps users to install the software after mirror image has been upgraded.
Prepare a flash disk with software (formatted in.weihong) in.
To install the software for the first time:
1. Insert the flash disk into USB slot of NK280B host.
2. After mirror image updating has been finished, press Z to enter BOOT interface.
3. Press F6 to open the list, and use arrow keys to select the target software.
4. Press Enter to start installation.
After installation finishes, new software will be opened.
Update BOOT Interface
BOOT update interface is involved in both process of mirror image updating and software
updating.
See figure below for the BOOT interface.
Public Files Use PUBLIC file in the USB flash disk. PUBLIC
files are stored in CHN\files and ENG\files.
47
To Next Page
Loading...
