WEIHONG NK280B - Page 7

Update Mirror Image...................................................................................................................................................46
Install Software...............................................................................................................................................................47
Update BOOT Interface...............................................................................................................................................47
NK280B Parameter Reference................................................................. 48
Parameter for Axis Direction.....................................................................................................................................48
Driver Parameters for Auto Adjustment...............................................................................................................48
Parameters for Encoder.............................................................................................................................................. 49
Parameters for Handwheel Operation...................................................................................................................50
Parameters for Workbench Range..........................................................................................................................50
Parameters for Prompt................................................................................................................................................50
Parameters for QEC...................................................................................................................................................... 51
Parameters for Tool Compensation........................................................................................................................52
Parameters for Tool Calibration...............................................................................................................................52
Parameters for Actions after Program End......................................................................................................... 53