36 EN WM 100 TD
WM 67841c 03/2015
4 Preparation
5. Fill the base of the humidifier with fresh, cold water up to the
mark (max. 400 ml).
6. Place the top of the humidifier on the base of the humidifier
from the back and press it on gently until it clicks into place.
7. Check whether the humidifier is correctly sealed or whether
water can leak out. To do so, run your hand over the underside
of the device.
8. Fit the respiratory air humidifier to the therapy device
(see " Installing the respiratory air humidifier", page37).
Result The respiratory air humidifier is filled.
Sterile or boiled water is only required in exceptional medical cases
when using this device at home. Do not use distilled water for
technical purposes, as it could contain microbiological pollution.
To Next Page
Loading...
Need help?
General
