Instructions for Assembly
Item number 116519-0000 Subject to technical modifications
Version 4 23.04.2014 Page 41/47
Cassita II/Cassita II LED
10 Test that the unit is working correctly
10.1 Safety notes
Physical injury
Performing function tests is not without its risks. The following steps must be taken:
When running the awning for the first time, the working range of the awning and the
area below it must be kept clear.
A visual inspection of the fixings and brackets must be performed after the awning
has been operated for the first time.
When carrying out test runs, never use automatic controls or switches if the awning is
not in the operator's line of vision (danger of awning starting unintentionally).
We recommend that you connect a test cable to the motor input.
The installation and setting instructions supplied by the manufacturer of the drive,
switches and controls must be observed.
Check the direction of rotation on the drive if connecting to automatic controls (e.g.
the awning must retract in windy conditions).
10.2 Checking the functions of the unit
The drive has been designed to run for 4 minutes. If this time is exceeded, the internal
thermo protector will switch off the drive. Depending on the outside temperature, the drive
can be operated again after 10 – 15 minutes.
Open and retract the awning once.
As you do this, check the following:
The fabric tension when the awning
is open
The position of the awning when
opened and retracted
That the awning housing closes
properly
DANGER
To Next Page
Loading...
Need help?
General
