Instructions for Assembly
Item number 116523-0000
We reserve the right to make technical
changes
Version 4 01.04.2014 Page 20/49
Opal Design II / Opal Design II LED
3. Mark where holes are to be drilled
(X) (first the front 2, then the back
2), drill the holes and fit the ceiling
angle to the ceiling.
2. Check the bracket alignment
1. Check the ceiling angles are aligned
flush, and adjust if necessary.
3. Fit the retaining plate
1. Gently screw the retaining plate (2)
to the ceiling angle (1) with the
screws.
To Next Page
Loading...
