CMP201D User Guide
Enable Destination MAC: Generally, you do not need to enable this option. This is reserved for
exceptional cases where the unicast stream cannot be received with unicast IP addresses. You
can enable destination MAC and streaming out by setting Destination MAC.
To use Multiplexing mode at service level
1. Click on pencil icon . There will always be a BaseBoard selection for the IP output and
other Output options depending on the module inserted.
2. Select the correct Output and Channel you want to output the service to.
3. Check Multiplex on the channel you want to output to. You can output multiple services to one
channel or output one service to multiple channels.
CE2-HDMI-02 >EAS Settings
This function need to be used together with CP2-EAS-00 module.
The parameters of EAS Source Multicast Address & Command Port & Data Port should be
consistent with those of CP2-EAS-00 module. Then the EAS module will be detected automatically
by CE2-HDMI-02 module so that the service(s) could be paved by EAS input(ASI or AV signal).
When it is triggered by an external IP or analogue signal, the services(s) will be switched to the AV or
ASI service from EAS module.
Service: There are 2 programs corresponding to 2 HDMI ports
Status: Paved/Unpaved
EAS Override: Tick the check-box to select the program(s) needing to be paved.
Click the Apply button on the right side to make the change take effect.
CE2-HDMI-02 > System
Please refer to CR2-DVBC/DTMB module.
To Next Page
Loading...
