i12 Manual Page 46 - Revision: 6-13-2023
6. Cold Water not cold
Cold Water Temp Probe Failure
If ice is being produced, but the cold water is not cold, replace the
cold water temp probe.
If Cold water is not cold AND Ice is not being produced, check that
the circulation pump is working and pushing water to the ice tray in
the compartment below the ambient tank. Replace if not working
correctly.
Ice Tray Rotation Failure
(Motor or Coupler)
If Cold water is not cold AND Ice is not being produced BUT the
circulation pump is working, check that the tray in the ice-making
compartment is rotating. If it is not, determine if the Tray Coupler
is broken and replace if it is. If not, check for proper operation of
the Tray Motor. Replace if necessary.
7. Ice not being produced
If Cold water is not cold AND Ice is not being produced, check that
the circulation pump is working and pushing water to the ice tray in
the compartment below the ambient tank. Replace if not working
correctly.
Ice Tray Rotation Failure
(Motor or Coupler)
If Cold water is not cold AND Ice is not being produced BUT the
circulation pump is working, check that the tray in the ice-making
compartment is rotating. If it is not, determine if the Tray Coupler
is broken and replace if it is. If not, check for proper operation of
the Tray Motor. Replace if necessary.
Compressor and Gas System
If Circulation Pump, and the Ice Tray Motor and Coupler are
working properly, check if compressor is operating normally. Check
heat levels. Compressor body should be warm to the touch and
condenser should also be slight warm. If compressor is extremely
hot and condenser is cold, call technical support. If compressor is
not running, call technical support.
To Next Page
Loading...
