Westermann WR 840 Battery - Cold Start; Starting At Operating Temperature; Starter Cord; After The Cold Start

30
9 Start-up
9.3.2 Cold start
P Slidethethrottleintotherearmost
   position(choke).
P START
9.3.3 Starting at operating temperature
P Slidethethrottleintotheposition
   slightlyaboveidle.
P Between MIN and MAX
9.3.4 Starter cord
P Firstpullthehandleofthestartercord
   lightlyuntilresistanceisfelt:thenpull
   hard.
Please let the handle of the starter cord
run back slowly. This prevents damage to
the engine.
9.3.5 After the cold start
P Iftheenginewasstartedwiththeaidofthe
   choke,setthethrottletothefastestor
   maximumpositionassoonasithaswarmed
   upandisrunningevenlywithoutchoke.
   Adjustthethrottletothedesiredengine
   speed. Optimal performance at full thrott-
le.
(Fig. 10 - Cold start controller)
(Fig. 11 - Operating temperature controller)
(Fig. 13 - Start operating temperature)
(Fig. 12 - Starter cord)
NOTICE