Weyer Easy Care - 13 Technical Data; Transport and Storage; Operating Environment

Instruction for use Examination and treatment table Easy Care
** Depending on model and configuration
D2151_01 - 09/2017 35/38
13. Technical data
13.1 Transport and storage
For transport and storage the following conditions should be observed:
Temperature: 0 – 70°C
Relative humidity: 15 to 90 % (no condensation)
Atmospheric pressure 210 to 1100 hPa
Before moving the examination and treatment table Easy Care, it is recommended to adjust it to the lowest
position. Otherwise it may topple over when moving over thresholds and obstacles. Strong vibrations should
be avoided, e.g. moving on cobble stone pavement or similar.
13.2 Operating environment
Temperature:
18 to 30°C
Relative air humidity:
15 to 90 % (no condensation)
Atmospheric pressure:
860 to 1100 hPa
Please also observe chapter 4 "Requirements of the location“
The examination and treatment table Easy Care is not suitable for the use in explosion-hazardous
areas

To avoid the risk of an electrical stroke this device must only be connected to a power supply with
earth conductor.

The examination and treatment table Easy Care must not be operated close to strong or high-
frequent electro-magnetic radiation sources such as HF surgery devices, MRT or similar. Under
unfavourable conditions this could cause faults.