WHILL C2 - Charging with the Battery Installed in the Device

27
WHILL Model C2/Ci2 User Manual
3
3. Charging the battery
3.2.1. Charging with the battery installed in the device
For safety reasons, it is not possible to turn on the device power while the battery is being charged.
1.
Move the device close to the outlet.
2.
Turn off the device power.
3.
Connect the charger and AC connector cord.
4.
Plug the charger into the wall outlet.
The charger indicator illuminates red.
When the charger indicator is red, it means that
the charger is connected to the wall outlet and not
connected to the battery.
Charger indicator
5.
Remove the battery charging port cap and connect the
DC connector to the battery charging port.
Check the orientation of the DC connector and then
connect it. The charger indicator begins flashing green,
and charging starts.
• If the charger indicator flashes red, the charger is
not properly connected. In this case, disconnect
and reconnect again.
• If the charger indicator flashes in red even though
you attempt to establish a connection several
times, a battery or charger malfunction may have
occurred.
• If the charger indicator turns green right away
even though the battery is not charged fully, a
battery other than the battery provided with the
device may have been used. Be sure that the
charger indicator flashes green.
Cap
DC connector