WHILL C2 - Page 80

79
WHILL Model C2/Ci2 User Manual
5
5. Assembly, adjustment, and disassembly
5.
When it is at the desired height, tighten the loosened
bolts.
Set the back support to the appropriate height and
tighten the bolts firmly with the specified tool. If a screw
is loose, tighten it.
Tool: hex wrench (or hex torque wrench) #5
Tightening torque: 5 Nm
6.
Install the back support cushion.
Return the back support cushion to its original position
and attach the fasteners.
7.
Install the battery.
For the installation procedure, refer to “5.2.4. Installing
the battery” on page 64.