WHILL F - Page 66

65
WHILL Model F User Manual
4
4. Charging the battery
5.
Remove the cap of the battery charging port and
connect the DC connector to the battery charging port.
Connect the DC connector so that the terminal inside is
aligned with the hole of the charging port.
The charger indicator begins flashing green, and
charging starts.
You can check the charge level of the battery on the
battery LED.
• Full charge: green
• Approx. 30% to less than full charge: orange
• Approx. 30% charge or less: red
• No charge: purple
Cap
Charger indicator
Battery LED
6.
Charging is completed when the charger indicator and
battery LED turn solid green.
The battery LED turns off shortly after charging
completes.
• If the charger indicator flashes red, the charger is
not properly connected. In this case, disconnect
and reconnect again.
• If the charger indicator flashes red even though
you attempt to establish a connection several
times, a battery or charger malfunction may have
occurred.
• If the charger indicator turns green right away
even though the battery is not charged fully, a
battery other than the battery provided with the
device may have been used.