EasyManua.ls Logo

Whirlpool WFC8090GX - Page 15

Whirlpool WFC8090GX
82 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
GENERAL INFORMATION
Whirlpool Smart All-In-One Washer & Dryer
n
1-11
Clean Washer Cycle Reminder
The Clean Washer with aresh® message will ash at the end
of a wash cycle when the washer has run 30 wash cycles. This
is a reminder to run the Clean Washer with aresh® cycle.
If the Clean Washer with aresh® cycle is not run, the message
will stop ashing at the end of a wash cycle aer running
three more regular wash cycles. Aer 30 more wash cycles are
completed, the Clean Washer with aresh® message will again
ash at the end of a wash cycle as a reminder.
Removing the Load & Go Bulk
Dispenser
To remove:
1. Li the bulk dispenser lid on the top of the washer/dryer.
2. Li up on the bulk dispenser handle and pull straight up
and out of the washer/dryer.
To replace:
1. Place the bulk dispenser back into the bulk dispenser
cavity on the top of the washer/dryer and make sure that
it is seated.
2. Close the bulk dispenser lid.
All-In-One Washer/Dryer Maintenance (continued)
Water Inlet Hose
Replace inlet hose aer 5 years of use to reduce the risk of
hose failure. Periodically inspect and replace inlet hose if
bulges, kinks, cuts, wear, or leaks are found.
When replacing your inlet hose:
n Mark the date of replacement on the label with a
permanent marker.
n Check that the old washer is not stuck on the washer inlet valve.
n Use a new washer in the new inlet hose to ensure a proper seal.
Non-Use and Vacaon Care
If moving, or not using your washer/dryer for a period of me,
follow these steps:
1. Unplug or disconnect power to washer/dryer.
2. Turn o water supply to washer/dryer to avoid ooding
due to water pressure surges.
HELPFUL TIP: Aach a reminder note to the washer/dryer
to turn the water back on before washers next use.
3. Clean the bulk dispenser. See “Cleaning the Bulk
Dispenser.
Winter Storage Care
IMPORTANT: To avoid damage, install and store washer/dryer
where it will not freeze. Because some water may stay in
hoses, freezing can damage washer/dryer. If storing or moving
during freezing weather, winterize your washer/dryer.
To winterize washer/dryer:
1. Shut o water faucet, disconnect and drain water inlet
hose.
HELPFUL TIP: Aach a reminder note to the washer dryer
to turn the water back on before washers next use.
2. Remove drain pump lter.
3. Put 1 qt. (1 L) of R.V.-type anfreeze in drum and run
washer on Normal cycle for about 2 minutes to mix
anfreeze and remaining water.
4. Unplug washer/dryer or disconnect power.

Table of Contents

Other manuals for Whirlpool WFC8090GX

Related product manuals