Whirlpool WFC8090GX - Removing the Rear Access Panel

COMPONENT ACCESS
Whirlpool Smart All-In-One Washer & Dryer
n
4-7
Removing the Rear Access Panel
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Failure to do so can result in death or
electrical shock.
Replace all parts and panels before operating.
To Remove the Rear Access Panel
1. Unplug washer or disconnect power.
2. Turn o water supply to washer.
3. Disconnect cold inlet water hose and remove the drain
hose from the standpipe or laundry tub.
4. Remove six (6) Phillips screws securing the rear access
panel to the back panel as indicated in Figure 1. Remove
rear access panel.
Remove 6 Screws
Figure 1