It is possible to use the timing light in this
mode to estimate speed on pumps/fans and
collect crank angle data where a speed
reference is not available. The range of this
feature is 150-1300 RPM. The
toggle button allows
for course / fine adjustment in the RPM
value.
NOTE: NEVER USE THIS MODE WHEN
YOU CAN USE THE ENCODER OR A
ONCE PER TURN MODE!
FCC Exposure Notice:
To maintain compliance with the RF exposure guidelines, place the unit at least 20cm from nearby persons.
Pour assurer la conformité aux directives relatives à l'exposition aux frequencies radio, le jouet doit êtreplacé à
au moins 20_cm des personnes à proximité.
This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the following two
conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause undesired operation of the
device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de
licence. L’exploitation est autorisée aux deux conditions suivantes:
(1) l’appareil ne doit pas produire de brouillage, et
(2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d’en compromettre le fonctionnement.
Any changes or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
This device has been designed to operate with the antennas supplied by Windrock. Antennas not
supplied by Windrock are strictly prohibited for use with this device. The required antenna impedance
is 50 ohms.
To Next Page
Loading...