settings set the Mode Dial to the respective setting.
WingtraOne takes a series of test pictures after you press the Ready-to-Fly button during the preflight procedure to check if the camera is setup correctly, i.e. to make sure
that the SD card is inserted correctly and triggering from the autopilot is possible. We recommend opening the WingtraOne cover and inspect the routine on the camera
screen. After pressing the "Ready-to-Fly" button the camera is switched off and on again, than the test pictures are taken (you can see the counter of remaining space on
SD card on top left of the screen going down), and finally the camera is switched off again. In case the screen is going black for >5s during the procedure, check if SD
card is inserted. If you run into trouble, check the WingtraOne RX1 Troubleshooting Section before submitting a support request.
Caution: The manual aperture ring can be set to any value only mechanically via the Aperture Selection Ring. There is no storage setting for the correct aperture in
manual mode.
Image Quality Settings
It is possible to increase the image quality settings to extra fine, and RAW + fine. These settings can improve the image quality even further. However, the file size of
individual images increases significantly from ~18MB with fine to ~38MB (extra fine) and ~44MB +18MB (with RAW and fine). The continuous write speed in the camera
during image acquisition is limited. To trigger reliably every image do not use the image quality setting extra fine below 1.4cm/px GSD (@75% frontal overlap), and below
2.1cm/px (@75% frontal overlap) for raw + fine setting. Please note: Image file size directly effects the postprocessing speed of geotagging, file copying and orthophoto
generation. To change the image quality setting go to the menu and browse to the first page in the image settings tab. Change the image quality setting to raw + jpeg or
extra fine. To use this setting in flight you have to save it to a memory recall button and adjust the mode dial to the respective number. The camera should be
preconfigured when you receive the unit to the following:
Mode dial position Image Quality
1 raw + jpeg (fine)
2 fine
3 extra fine
If the settings are not correct you can set them yourself. To save the setting on memory recall go to page 8 in the image setting tab chose "memory" and select "1" or "3".
Finally turn off the camera via the Power switch on the camera. To access the setting for the next flight adjust the mode dial to the desired memory recall position. Note:
once you overwrite the preconfigured settings they cannot be automatically restored.
For more information about the camera see the official Sony Documentation.
To Next Page
Loading...
