Changes for Revision C of the SmartPAC PRO User Manual
(1143100)
This revision of the SmartPAC PRO user manual covers SmartPAC 2 software version 10.00 and
higher. The changes include:
• Added figure showing serial number on SD card (Chapter 2)
• Added detail on wiring for pendant installation (Chapter 2)
• Added or enhanced DiProPAC die protection features (Chapter 6)
• Added S-Codes to Chapter 8 – SmartPAC PRO Fault Messages
• Added Appendices:
Appendix A SmartPAC Preventive Maintenance (PM) Monitor (Optional)
Appendix B Updating SmartPAC PRO Firmware
Appendix C Reporting Downtime and Scrap to SFC
To Next Page
Loading...
