SmartPAC PRO User Manual 1143100
Chapter 1 – Introduction to SmartPAC PRO 41
SmartPAC PRO Specifications
Table 1-3. SmartPAC PRO Specifications
Main enclosure: 14.1 x 13.1 x 5.3 in (358 x 333 x 134 mm), NEMA 12,
shock mounted. Weight 19.3 lb
Panel mount: 13.7 x 12.8 in (348 x 324 mm)
Resolver: 0.75 in (19 mm) keyed shaft; rated shaft loading: 200 lb axial,
200 lb radial
Electrical
(System Power)
Input: 115/230 ± 10% Vac50/60 Hz 30VA
Or 24Vdc ± 15% 37W
When installed, this equipment shall have in close proximity and easily
accessible, a switch or circuit breaker marked as the disconnect switch.
Indoor use only
Temperature 32 to 122 °F (0 to 50 °C)
Relative humidity: Indoor factory conditions
Altitude 6562 ft (2000 m)
12.1 in (307 mm) color active matrix TFT liquid crystal display (LCD),
Power LED, Brake Warning LED
Allows storage of settings for 2000+ tools
± 2/3 ° (± 1.33 ° for high speed version )
Good parts, strokes, 3 batch with presets (7 digits),
Number-of-hits-on-tool counter: counts all hits on tool; resettable to 0
after maintenance
Inputs for resolver, position sensor (resolver slippage detection), remote
reset input, setup mode input
Input check circuit: rating 12 – 250 Vac or Vdc selectable, 15 mA max
USB and RJ-45 connectors
Outputs for top stop, emergency stop: ratings 0-4A resistive at 120Vac
or 30Vdc max; Normally open – held closed. Fault condition or power
off opens relay(s)
Connects via Ethernet to local area network; data viewed via the
internet using SmartView remote viewing utility; allows backup of
programmed tool settings to a network drive.
To Next Page
