WisyCom MCR54 - Edit RX1÷RX4; Name; Frequency; Ch. Modulation

MCR54 / MCR54-DUAL User Manual
10
Edit RX1÷RX4
Select Edit RX menu to set RX parameters for each receiver:
Edit RX1/RX2/RX3/RX4
Name
"12 characters max"
Frequency
Group / Channel and Frequency selection
Ch. Modulation
Wide/ Narrow
Compander
ENS Wisy/ ENC Wisy/ ENR Wisy…
Sq. mode
User/ Normal/ LongRange
Audio
AES level
0 to -30 dBFs (1dB step)
Base level
18 to -24 dBu (1dB step)
Top level
18 to -24 dBu (1dB step)
PTT
No/Yes
PTT Base
T+, T-, T, OFF
PTT Top
T+, T-, T, OFF
Phase
0/180
Cal. Tone
Cal. Tone
OFF/ON
Frequency
400/600/1000 Hz
Level
-30 to 0 dB (1 dB step)
Sync
“Active automatic sync with a transmitter”
Name
Selecting Name, it’s possible to edit the name of the receiver (12 characters).
Frequency
Select current group and channel. If the specific group/channel is not locked, frequency can be
edited in this menu.
Ch. Modulation
Narrowband or Wideband software selectable according to transmitter modulation.
NOTE: During the SYNC process the receiver sends the type of modulation (NB or WB) and the TX adapts
automatically to the receiver’s modulation settings accordingly.
Compander
MCR54 supports 5 different types of “Compander systems” (others on request through Digicom):
ENS: designed for voice and music applications.
ENR-Wisy: designed for maximum noise reduction. Ideal for use in louder environments.
ENC-Wisy: designed for maximum audio fidelity (use this in case of special vocal application or to
remote instruments). Ideal for use in quite environments.