MCR54 / MCR54-DUAL User Manual
Mini XLR 5-pin connector
2 channels analog audio outputs electronically balanced or
4 channels digital audio outputs (AES3)
1 GND
2 CHANNEL1+
3 CHANNEL1-
4 CHANNEL2+
5 CHANNEL2-
LED power supply
GREEN The receiver is on with an external power supply
PALE GREEN The receiver is on with battery
GREEN BLINKING The external power is low
PALE GREEN BLINKING The power of the battery is low
RED BLINKING Relative transmitter battery is low:
- slowly blinking if 25% lifetime
- quickly blinking if 12% lifetime
LED receiver status
OFF Relative receiver is not active
RED RF level below squelch and/or Noise squelch on both diversity receivers
RED BLINK frequency is out of filter (32MHz) see NOTE page 3
BLUE RF level above squelch and/or Noise squelch and receiver A is active (ANTENNA A)
GREEN RF level above squelch and/or Noise squelch and receiver B is active (ANTENNA B)
Headphone output (jack 3.5 mm)
“PWR/EXIT” BUTTON
Push and keep this button to power on/off the receiver. The on/off status is permanently
memorized into the non-volatile memory, this way the system can be setup to automatically
turn on the receiver when power up.
During menu navigation push this button to exit from current menu (escape function).
“MENU/SEL” BUTTON
Push this button to navigate function menu’s and to confirm the chosen setup.
“Arrow down/SCAN” BUTTON
Push and keep this button to start the automatic scan.
During menu navigation push this button to move-down and select the previous item.
“Arrow up/SYNC” BUTTON
Push and keep this button to start a synchronization with a Wisycom transmitter (follow
instructions on display). Before starting synchronization IRDA must be enabled on Wisycom
transmitter.
During menu navigation push this button to move -up and select the previous item.
To Next Page
Loading...
