WisyCom MCR54 - Display menu; Status screen; Rotatory menu

MCR54 / MCR54-DUAL User Manual
7
Display menu
Using navigation buttons it is possible to quick & easy navigate through the menu:
- SEL to enter a level or SAVE
- EXIT to exit a level
- Arrow up/down to circle on the same level
Status screen
Rotatory menu
From FW version 1.10, pushing “Arrow down/scan” button or “Arrow up/sync” button, it’s possible
to enter in a rotatory menu where you can see the main parameters of the single receiver as
frequency, group, channel, compander, RF level and audio level:
Group
Channel
Frequency
Audio Modulation Bar
(from -42 to 0 dB)
Peak deviation ≥ 56KHz
RF bar
(8 steps of 10dBµV,
from 10 to 80 dBµV)
TX Battery
Level
RX Number
WARNING!
RX Number and Rx red
LED blink if frequency is
out of filter (32MHz)
see NOTE page 3
Group
Channel
Frequency
RX Number
RX Name
TX Battery
Level
Audio Modulation Bar
(from -42 to 0 dB)
Peak deviation ≥ 56KHz
Antenna A & B
RF bar
(8 steps of 10dBµV,
from 10 to 80 dBµV)
Squelch
mode
Compander