Objects are printed OK, but the edges start to come unstuck
This is because the base has not been levelled correctly. If the distance between
the extruder nozzle and the print base is too great, the plastic at the edges of the
object will not adhere correctly and will become unstuck. Additionally, you can
improve adherence by applying a small amount of lacquer onto the base before
printing.
Can I pause the Witbox while it is printing?
Yes, you can pause an ongoing printing operation by pressing the control wheel
and selecting the option Pause Print. When you want to resume printing, go back
to the same menu and select the option Resume Print.
Can I stop the Witbox while it is printing?
Yes, you can stop an ongoing printing operation by pressing the control wheel
and selecting the option STOP Print.
The lament has broken inside the Fibonacci guide tube
If this happens, you must remove the broken lament manually. Disconnect the
guide tube from the extruder by pressing downwards on the oval bulkhead
connector while pulling the guide tube upwards. This will give you access to the
tube and allow you to remove the broken lament.
Technical support
Visit the website below for details of the e-mail address for our technical support
team. Contact us if you need help or if you have any queries regarding your
Witbox.
www.bq.com/gb/technical-support.html
To Next Page
Loading...