Wood-mizer MP100 Series - Page 33

MOULDER ASSEMBLY
Bed Frame Assembly
MOULDER ASSEMBLY 15doc042320 3-13
3
See Figure 3-7.
8. Assemble a log clamp to a bed rail on each bed section using the existing hex head bolts and nylon lock
nuts.
9. Install the log side supports as shown in the Figure 3-8. Tighten the nuts so that the side supports can be
moved with little resistance. Adjust the side supports. See Section 6.11 of the LT15 sawmill Operator’s
Manual.
FIG. 3-7
M10 Hex Nylon Lock
Nut
13 Flat
Washer
M10x75 Bolt
10.5 Washer
086659-1 Bed Section
Connector
M12x120 Bolt
Mounting Pin
086182-1
M10x25 Bolt
10.2 Split Lock
Washer
M12 Hex Nylon Lock
Nut
Bumper P12165
3/16x1 Pin,
F05012-21
094250-1