Wood-mizer MP100 Series - Default Chapter; Table of Contents

4 SW-07doc042320Table of Contents
Table of Contents Section-Page
SECTION 1 INTRODUCTION 1-1
1.1 Machine Description ..............................................................................1-1
1.2 Machine and Site Preparation.................................................................1-2
1.3 The major components of the moulder...................................................1-2
1.4 If You Need To Order Parts ...................................................................1-4
1.5 If You Need Service ...............................................................................1-4
SECTION 2 SAFETY 2-1
2.1 Safety Symbols.......................................................................................2-1
2.2 Safety Instructions..................................................................................2-1
SECTION 3 MOULDER ASSEMBLY 3-1
3.1 Mounting Parts of MP100/150 Moulders...............................................3-1
3.2 Unpacking the Moulder..........................................................................3-7
3.3 Bed Frame Assembly .............................................................................3-7
3.4 Frame Leg Adjustment.........................................................................3-14
3.5 Head Assembly....................................................................................3-15
3.6 Manual Feed Rope Assembly...............................................................3-19
3.7 Power Feed Rope Assembly.................................................................3-22
3.8 Auxiliary Bed Rail................................................................................3-25
SECTION 4 SETUP & OPERATION 4-1
4.1 Moulder Setup ........................................................................................4-1
4.2 Log Clamp Operation .............................................................................4-7
4.3 Mounting the Planing Knives.................................................................4-8
4.4 Mounting the Moulding Knives ...........................................................4-11
4.4 Moulder Operation, MP100..................................................................4-16
4.5 Moulder Operation, MP150..................................................................4-21
4.6 Machine Start-Up (MP100)..................................................................4-26
4.7 Machine Start-Up (MP150)..................................................................4-28
4.8 Track Roller Distance Adjustment .......................................................4-30
SECTION 5 SETWORKS OPERATION 5-1
5.1 Moulder Controller Panel.......................................................................5-1
5.2 Start-up settings of the controller ...........................................................5-2
5.3 Memory Buttons (A, B, C, D, E)............................................................5-5
SECTION 6 MAINTENANCE 6-1
6.1 Wear Life................................................................................................6-1
6.2 Sawdust Removal ...................................................................................6-1
6.3 Head Track & Rollers.............................................................................6-1