SETUP & OPERATION
Control Overview
4
4-17 EGdoc042320 Operation
Starts the cutter motor. The motor can be started only when the safety handle is being held.
4. Main Disconnect Switch
Disconnects power from all electrical circuits of the machine.
5. Power ON Control Light
Indicates the power supply.
6. Emergency Stop
Push the emergency stop button to stop the cutter motor. Turn the emergency stop clockwise to
release the stop. The machine will not restart until the emergency stop is released.
7. Cutter Height Scale
Indicates the cutter height.
8. Cutter Height Locking Handle
After setting the cutter height, secure the head in this position using the locking handle.
IMPORTANT! Never start planing/moulding without locking the head.
9. Up/Down and Feed Crank
Allows forward/backward and up/down movement of the cutter head. IMPORTANT! Never push or
pull the cutter head manually (without using the crank handle).
To Next Page
Loading...
