To Next Page
T
Tara SchaeferSep 13, 2025
What happens when both speed sensors fail on a Woodward 723PLUS Controller?
- KKatherine MezaSep 13, 2025
The 723PLUS should go to the minimum fuel position.
What happens when both speed sensors fail on a Woodward 723PLUS Controller?
The 723PLUS should go to the minimum fuel position.
General| Output Voltage | 24V DC |
|---|---|
| Approvals | CE, UL, CSA |
| Type | Digital Controller |
| Operating Temperature | -40 to 70 °C |
| Communication Protocols | Modbus RTU, CAN |
| Outputs | Analog and Digital Outputs |
| Protection | Overvoltage |
| Applications | Industrial |
| Actuation | Electric |
| Redundancy | Optional redundancy configurations available |
Details the control's use in generator set applications.
Lists available hardware configurations and voltage ranges.
Steps to minimize or eliminate electrostatic discharges when working with the control.
Specifications for input voltage and power consumption.
Details on external wiring and shielding requirements.
Details on serial ports for PC and Modbus communication.
Steps to verify installation before set point entry.
Software for setup, testing, and troubleshooting via PC.
Usage and navigation of the handheld programming terminal.
Details of various configuration options and settings.
Procedures for initial engine start-up and control calibration.
Tuning parameters to optimize engine speed response and stability.
How the control manages fuel delivery for stable engine operation.
Explanation of constant and variable dynamics for engine response tuning.
Modes and operation for controlling generator load.
Procedures for testing and calibrating the control system.
Guidelines for sending controls back for service.
Technical details and requirements for LinkNet I/O modules.
Explains the functionality and behavior of different LinkNet modules.
List of configuration menu items for recording settings.
List of service menu items for recording settings.
Specifications for various analog and discrete inputs.
Specifications for analog and relay outputs.
