Manual 37240C GCP-30 Series - Genset Control
Settings in LeoPC1
LeoPC1 will be installed according to the manual.
The configuration files of the device are copied to the PC. With this, the .cfg files are copied to the main path and
the other files are copied to the intended folders.
NOTE
This application is limited to 8 GCPs per interface at the moment. Please contact Woodward for bigger
plants.
The .cfg file with the contraction "_xUS" in the file name is to be used for access via CAN.
x stands for the number of parallel generators in the application here.
The driver Gateway - RS-232 is to be selected under Devices -> Settings -> Driver.
© Woodward Page 15/38
To Next Page
Loading...
