IQ SENSOR NET MIQ/T2020 Operation
4 - 1
4 Operation
4.1 Introduction
The MIQ/T2020 terminal is a control unit for the IQ SENSOR NET.
The terminal can be used to:
l Display measured values
l Start calibration
l Perform system and terminal settings
l Display messages.
Note
To guarantee data security within the IQ S
ENSOR NET, access to the
following functions is only possible from one terminal at the same time:
l Opening the Settings/Einstellungen menu
l Starting the calibration
l Assigning sensors or output modules as substitutes.
If one of these functions is active at another terminal, a note appears
on the display.
To Next Page
Loading...
