WYLER BlueSYSTEM BASIC - Description of the 4.1 Starting the Blue

page 15 of 84
4 DESCRIPTION OF THE BLUEMETER BASIC
The BlueMETER BASIC is an intelligent digital display unit developed by
WYLER AG for the inclination measuring instrument BlueLEVEL BASIC.
Besides the excellent measuring accuracy the BlueLEVEL instruments supply
a fully digital signal for transmitting these over long distances without any loss
of quality.
The BlueMETER BASIC is
- a display unit
- an interface between instrument and PC/Laptop
On the BlueMETER BASIC various parameters may be set or changed, such
as:
- Measuring units
- Address of instruments/sensors, port definition (Port)
- Filter-settings
- Relative base length etc.
It is possible to send measured data via a RS 232 port to a printer, a PC/Laptop or the WYLER software
LEVELSOFT PRO, MT-SOFT and LabEXCEL
•
Compact and pleasant design in aluminium housing and state of the art technology.
•
Wireless data transmission based on the internationally approved Bluetooth™-standard
•
Large and well readable LCD display
•
Display showing the automatically recognized instruments connected
•
Powered by standard 1.5 V batteries type “C”
•
In compliance with CE regulations and all applicable EMC regulations
4.1 STARTING THE BLUEMETER BASIC (AND THE INSTRUMENTS BLUELEVEL BASIC)
Please read the manual carefully before working with the BlueMETER BASIC and the BlueLEVEL BASIC for
the first time.
Switching the BlueMETER BASIC on
Press the key <ON/MODE> until all 5 LEDs are ON, release the key and "SYSTEM TEST" will appear in the
display. After the start-up you will see the actual measuring value of the instruments connected in the last saved
measuring configuration and measuring unit.
Using the battery, mode the instrument is automatically shut off after 60 minutes.
If the key <ON/MODE> is pressed for more than 10 seconds when starting the BlueMETER BASIC all the LEDs
start blinking and the automatic shut-off is deactivated.