WYLER BlueSYSTEM BASIC - Default Chapter; Table of Contents

page 3 of 84
CONTENT
SUBJECT PAGE
1 BASICS / INTRODUCTION 6
2 PREPARATION AND START-UP OF THE MEASURING INSTRUMENTS / BEFORE STARTING 7
2.1 INSERTING RESPECTIVELY REPLACEMENT OF BATTERIES IN BLUELEVEL BASIC
AND/OR BLUEMETER BASIC
7
2.2 INITIAL START-UP OF THE INSTRUMETNS 8
2.3 CONNECTING THE INSTRUMENTS (BLUELEVEL BASIC AND BLUEMETER BASIC) 9
2.4 COMBINE A GROUP OF INSTRUMENTS USING THE FUNCTION "JOIN" 10
2.4.1 PROCEDURE "JOIN" WITH CABLE CONNECTION 10
2.4.2 PROCEDURE "LEAVE" 11
2.5 RESTART OF A MEASURING GROUP 11
3 DESCRIPTION AND FUNCTION OF THE BLUELEVEL BASIC WITH AND WITHOUT RADIO
MODULE
12
3.1 THE BLUELEVEL BASIC (OVERVIEW) 12
3.2 VIEW OF FUNCTIONAL KEYS BLUELEVEL BASIC 13
3.2.1 REAR VIEW 13
3.2.2 TOP VIEW OF THE BLUELEVEL BASIC WITH RADIO 13
2.3.2 TOP VIEW OF THE BLUELEVEL BASIC WITHOUT RADIO 14
4 DESCRIPTION OF THE BLUEMETER BASIC 15
4.1 STARTING THE BLUEMETER BASIC (AND THE INSTRUMENTS BLUELEVEL BASIC) 15
4.2 TYPICAL CONFIGURATIONS WITH BLUEMETER BASIC AND BLUELEVEL BASIC 16
4.3 FUNCTIONAL MENU WITH BLUEMETER BASIC USING THE FUNCTION KEY 17
4.4 FUNKTIONEN AM BLUEMETER BASIC ÜBER DIE FUNKTIONSTASTEN 18
ADDITIONAL FUNCTIONS OF THE BLUEMETER BASIC 27
4.5 TEACH-IN OF THE IR-TRIGGER (ZAPPER) TO THE BLUEMETER BASIC AND TO THE
BLUELEVEL BASIC)
28
4.6 OPERATING THE BLUEMETER BASIC 29
4.6.1 DESCRIPTION OF THE VARIOUS KEYS 29
4.6.2 DESCRIPTION OF VARIOUS DISPLAY FORMS ON THE BLUEMETER BASIC 32
APPENDIX 36
A BASICS AND GENERAL REMARKS ABOUT BLUESYSTEM BASIC AND INCLINATION
MEASUREMENT
36
A1 INTRODUCTION TO THE BLUESYSTEM BASIC 36
A2 INSTRUMENT’S OVERVIEW THE INSTRUMENTS OF THE BLUESYSTEM BASIC - FAMILY IN
DETAIL
37
A3 MEASURING PROCEDURE / GENERAL HANDLING
TYPICAL CONFIGURATIONS WITHOUT RADIO TRANSMISSION
39
TYPICAL CONFIGURATIONS WITHOUT RADIO TRANSMISSION 39
A4 BASIC SETUP OF THE INCLINATION MEASURING INSTRUEMNTS / PLUS - MINUS RULE 40
A5 ABSOLUTE MEASUREMENT / RELATIVE MEASUREMENT / DIFFERENTIAL MEASUREMENT 41
A6 GENERAL REMARKS ABOUT "ANGLES" AND "INCLINATION" 43
A7 HEIGHT RELATED TO THE STEP LENGTH 44
A8 ZERO SETTING BY REVERSAL MEASUREMENT (ABSOLUTE ZERO) 45
B APPLICATIONS 47
B1 MEASURING ABSOLUTE 47
B2 RELATIVE MEASUREMENT 47
B3 DIFFERENTIAL RESPECTIVELY REFERENCE MEASUREMENT USING AN ENGINEER SET 47
B4 ANGULAR MEASUREMENTS 50
B5 LINES AND FLATNESS MEASUREMENT (MANUAL PROCEDURE) 51
C WYLER SOFTWARE LEVELSOFT PRO 52