page 6 of 84
The following
ADDITIONAL MANUALS may be downloaded from http://www.wylerag.com:
• LEVELSOFT PRO, the software for measuring flatness and inclination with
WYLER inclination measuring instruments
• MT-SOFT, that gives the possibility to measure individual elements of machine tools with
standard inclination measuring instruments. The measured results can be saved and at a later
stage used for comparison and put together to receive a thorough result of the over all accuracy
of the machine tool.
• COMPENDIUM, the guide to our products, technology and to a variety of applications.
• Description of the interface RS485
If for any reason it is not possible to download the respective data we will gladly supply against a nominal charge a
CD "ALL-IN-ONE" with all the manuals in different languages included
1. BASICS / INTRODUCTION
The new
BlueSYSTEM BASIC series
has been developed as a basic model to the well known and well proven
measuring instruments of the BlueSYSTEM family with wireless data transmission. Compared to the existing
systems with wireless data transmission the BlueSYSTEM BASIC series has an excellent price/performance ratio
and is easier to operate.
The BlueSYSTEM BASIC is available with wireless data transmission or cable transmission
. It is however
possible to upgrade the system without wireless data transmission at a later stage by WYLER to use
BLUETOOTH™ wireless technology.
As its predecessor this newest generation of high precision electronic inclination measuring instruments is
specifically suitable for the precision measurement of smallest angles. Applications are therefore in particular the
measurement of flatness of surface plates or the measurement of the geometry of machine tools. The sensor itself,
the heart of every precision measuring instrument, has been further developed as well, to allow precise
measurements even under critical environmental conditions.
The new measuring instruments of the BlueSYSTEM BASIC family can not be used as stand-alone instruments as
they do not feature an integrated display. The instrument must be combined with an external display unit
(BlueMETER BASIC) in a set.
A set of instruments, also called ENGINEER SET, normally consists of one or two BlueLEVEL BASIC and one
BlueMETER BASIC, forming the ideal tool for measuring flatness and machines under work shop conditions.
Furthermore the ENGINEER SET can be used for any levelling task or analysis of rotations.
To Next Page
Loading...
