WYLER BlueSYSTEM BASIC - Inserting Respectively and; or Blue; 2 Preparation Ands

page 7 of 84
2 PREPARATION AND START-UP OF THE MEASURING INSTRUMENTS
B
EFORE STARTING
2.1
INSERTING RESPECTIVELY REPLACEMENT OF BATTERIES IN BLUELEVEL BASIC
AND/OR BLUEMETER BASIC
2.1.1 E
XCHANGE OF BATTERIES IN THE BLUEMETER BASIC
The batteries are not installed in the new instruments they are delivered separately. It is recommended to remove
the batteries when transporting the instruments.
3 pieces 1.5V, Size “C” ALKALINE
2.1.2 INSERTION RESPECTIVELY EXCHANGE OF THE BATTERIES IN THE BLUELEVEL BASIC
The lowest voltage is 1,7 Volt. After a further voltage drop the red LED "low Power" on top of the handle will start
blinking. The batteries should then be replaced.
2 pieces 1.5V, Size “C” ALKALINE