page 65 of 84
K2 BLUETOOTH EQUIPMENT
BlueSYSTEM-Instruments are equipped with OEM Serial Port Adapter 33i, 2nd Generation
With Bluetooth™ wireless technology
Manufacturer: connectBlue AB
Stora Varvsgatan 11 N: 1
SE-211 19 Malmö, Sweden
Product Name: OEM SPA33i, with internal antenna (SMD-Type)
OEM Module ID: cB-0702-01
Type: BT-Class 1 / max. +20dBm
RF-Output Power: < 16dBm/100kHz e.i.r.p.
Antenna: integral (SMD)
Qualified Bluetooth Product, with
Bluetooth ID: B00931
QPN: GRA_001_03.pdf
K3 FCC Compliance
FCC Statement for cB-0702-02
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or televisions reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help
This device contains
FCC ID: PVH070201
To Next Page
Loading...
