WYLER BlueSYSTEM BASIC - Page 82

page 82 of 84
O
ON/MODE 4.4 18
ON/MODE - KEY 4.6.1 29
OPERATING THE BLUEMETER BASIC 4.6 29
OVERVIEW OF THE BLUEMETER BASIC 4.3 17
P
PIN-DEFINITION FOR BLUELEVEL + BLUEMETER, BLUELEVEL +
BLUEMETER BASIC AND BLUETC
H4 60
POWER UP (FLOWCHART) L1 68
PREPARATION AND STARTUP 2 7
R
RADIO TRANSMISSION (FLOWCHART) L9 76
REAR VIEW BLUELEVEL BASIC 3.2.1 13
RECTANGULARITY RESP. PARALLELISM OF MACHINE SPINDLE IN RELATION. TO WORK TABLE B3 47
REFRESH (FLOWCHART) L4 71
REL ZERO 4.4 21
REL ZERO OFFSET 4.4 18
RELATIVE MEASUREMENT B2 47
RELATIVE MEASUREMENT / DIFFERENTIAL MEASUREMENT / ABSOLUTE MEASUREMENT A5 41
RELATIVE ZERO / REL.ZERO (FLOWCHART) L5 72
REPAIR AND SERVICE I 61
REPLACEMENT OF BATTERIES IN BLUEMETER BASIC 2.1 7
RESET TO FACTORY PRE-SETTINGS G1 58
REVERSAL MEASUREMENT 4.4 25
REVERSAL MEASUREMENT A5 41
REVERSAL MEASUREMENT (ABSOLUTE ZERO) A8 45
S
SAMPLING (FLOWCHART) L2 69
SEND/ESC- KEY 4.6.1 30
SENSITIVITIES A3 39
SENSOR 4.4 18
SENSOR (FLOWCHART) L3 70
SENSOR-ADDRESS 4.6.2 35
SERVICE- AND MAINTENANCE CONTRACTS I2 62
SERVICE AND REPAIR I 61
SHUT-OFF SYSTEM 4.1 15
SMALL ANGLES B4 50
SOFTWARE FOR THE DEFINITION OF MACHINE TOOL GEOMETRY MACHINE TOOL INSPECTION
SOFTWARE MT-SOFT
D 54
SPECIAL FUNCTIONS G 58
STARTING THE BLUEMETER 4.1 15
STARTUP AND PREPARATION 2 7
STATUS OF BATTERY POWER "BATT" 4.6.2 33
STORAGE INSTRUMENTS J1 63
STORAGE INSTRUMENTS / CARE AND HANDLING OF THE BATTERIES J 63
STRAIGHTNESS OF TABLE MOTION B3 47
SYSTEM CHECK 4.6.1 30
T
TEACH-IN OF THE IR-TRIGGER 4.5 28
TECHNICAL DATA BLUELEVEL BASIC H2 59
TECHNICAL DATA BLUESYSTEM BASIC H 59
TECHNICAL DATA OF THE BLUEMETER BASIC H3 60
TECHNICAL DATA OF THE RADIO MODULES BLUESYSTEM BASIC (OPTIONAL) H1 59
TOP VIEW BLUELEVEL BASIC 3.2.2 13
TORSION IN GUIDE WAYS AND WORK PIECE SURFACES B3 49
TYPICAL CONFIGURATIONS WITHOUT RADIO TRANSMISSION A3 39
UNIT (FLOWCHART) L6 73
V
VIEW OF FUNCTIONAL KEYS BLUELEVEL BASIC 3.2 13
W