SpectraLight QC
7
1. Place the bottom panel (1) on a clean, smooth surface. Refer to Figure 1.
Figure 1. Bottom panel
2. Position the rear panel (2) bottom tabs into the bottom panel (1) rear slots. Fasten the rear panel to the
bottom panel by securing it with three screws as shown in Figure 2.
Figure 2. Rear into bottom panel
3. While supporting the rear panel (2), position the left panel (3) with the smooth side out over the top edge
of the rear panel (2).
4. Slide the left panel (3) downward along the interlocking channel until the left panel (3) front tab inserts into
the bottom panel (1). Fasten the left panel (3) to the bottom panel and rear panel by securing it with four
screws as shown in Figure 3.
Figure 3. Left panel into rear and bottom panel
To Next Page
Loading...
